How to Become a Rope Access Technician

Getting paid to climb may not be everyone’s dream but if it is yours, then you need to qualify as a Rope Access Technician by enrolling in IRATA Level 1 training course.

Machinery & Engineering

Afterward, you can decide to take it to Level 2 & Level 3.

What does a rope access technician do?

Rope access technicians climb difficult-to-reach and high-up locations using a practical ropework instead of a cradle, scaffolding, or another aerial work platform. They ascend, descend, and traverse ropes while working and suspended by a harness.

Most common applications for rope access include the following:

  • Window cleaning, repair, and maintenance of high-rise buildings.
  • Inspection, construction, and painting on offshore power plants and oil platforms.
  • Assist in the construction of stadiums, spires, and other structures with unique shapes.
  • Install banners, flags, fireworks, lighting, and other events rigging and installations.

Due to the risks involved, rope access technician must be equipped with a climbing helmet, seat harness, chest harness, full-body harness, safety back-up device, and ascender.

Once you’re ready, find Sydney IRATA Level 1 training centre. Contact Atlas Access today.

More than anything, they need the appropriate Sydney IRATA Level 1 training.

Why do you need training in IRATA Level 1 in Sydney?

Safety and protection

According to an article published in WorkCover Queensland, there are two serious incidents related to the use of rope access systems that happened in Gold Coast. Both resulted in serious injuries.

The cause? Someone chose and use the incorrect rope access system.

In the first incident, the working and safety lines were made to pass the top of a glass balustrade. Due to the rope’s load, the glass panel broke and cut the lines that were holding the worker suspended up in the air.

In the second incident, an incorrect set up was used, resulting in the worker’s fall. Due to the pendulum effect, the worker kept repeatedly swinging back across and down the building.

If only they knew better. Perhaps, they failed to take the IRATA Level 1 course.

Better job performance

When you know exactly what you’re doing, you are confident as you go about your job. You won’t hesitate to carry out the task and complete it.

Moreover, industry safety standards require that:

  • The technician should have at least two attachments, complete with an independent anchorage point for each.
  • Every rope supporting a worker must have a fail-safe descent mechanism.
  • Lanyards must be used to hold secondary tools and equipment. These are then attached to the harness.
  • Any job must be done by at least two trained technicians, one of which is capable of rescuing the other if needed.
  • All rope access technicians must pass IRATA Level 1 and independently assessed.
  • All codes of practice and working systems must be carefully refined and used.

What do you need prior to IRATA training?

You should practise your knots, particularly Alpine butterfly, Barrel knot, Double Figure of Eight on the bight, Figure of Eight, and Overhand knot.

You should be medically and physically fit as well since the course will be challenging. Learning the techniques of rope access manoeuvres using a pre-rigged rope and basic hauling and rescue is no walk in the park, after all. For more details, visit at